SKF Bearing Heater 20mm To 400mm Bore Size TIH100M 230V

This bearing heater from SKF has been designed with easy application in mind. It uses a special method of heating based on high-frequency induction to deliver maximum efficiency. Advanced electronics heat the bearings to the temperature you set, making them easier to mount onto a shaft. This means you can install them without using hand tools, which can cause damage to the bearing or the shaft. Once mounted, the bearing cools down, resulting in a strong interference fit.

• Outside coil to optimise efficiency
• Remote control panel for increased user safety
• Capable of heating a 28 kg bearing in under 20 minutes
• Supply voltage of 230 V
• Total weight (including yokes) of 42 kg
• Dimensions are 570 (W) x 230 (D) x 350 mm (H)
• Heat-resistant gloves included

• Repairing or building power transmissions
• Machine building
• Equipment manufacturing

The SKF bearing heater can also be used to heat other workpieces, such as gears and pulleys.

The SKF bearing heater can also be used to heat other workpieces, such as gears and pulleys.

SKF Electric Induction Heaters and Hot Plates enable bearings and other machinery components to be heated prior to installation. The induction heaters and hot plates are suitable for use with a variety of component sizes (actual sizes accepted depend on which induction heater or hot plate is used) and individual components may be heated to 200/250°C. SKF induction heaters and hot plates are thermostatically-controlled, and for safety reasons, overheat protection is also incorporated into the units to ensure that the induction heater or hot plate is switched off in the event of thermostat failure.