Igus Bearing Block WJ200UM-01-16 DryLin W Series

This bearing block provides guided linear motion for industrial systems, designed for integration into DryLin W assemblies where a compact slider is required. It combines a lightweight carriage with a construction suited to repeated linear travel in automation and mechanical layouts, enabling controlled movement along rails while meeting standard fastener requirements.

• Static load capacity 2100N enhances load-bearing capability
• Die-cast zinc carriage reduces overall mass and increases rigidity
• Slider carriage supports smooth linear guidance and positioning
• Carriage length 36mm permits compact installation in confined spaces
• Carriage width 34.5mm allows stable lateral support during operation

• Suitable for pick-and-place mechanisms in automation cells
• Ideal for rail-mounted sensor positioning
• Used for drawer-style actuator stages
• Can be used for linear slides in small CNC or dispensing systems

It is compatible with DIN 912 fasteners, allowing straightforward attachment using commonly specified socket-head cap screws.

The die-cast zinc construction provides dimensional stability and resists deformation under load, contributing to consistent contact geometry and predictable wear rates in moderate-duty cycles.

Yes, the short 36mm carriage length combined with a 34.5mm width offers a compact footprint for installations with constrained envelope dimensions.

Use the 2100N static load figure when determining structural supports and safety margins for stationary or low-speed load scenarios.